Glow in the Dark Hemp Jewelry – DIY

Glow in the Dark Jewelry

Check out this great product from Hemptique.com.  It’s this awesome glow in the dark cord! You can make all kinds of awesome things with it. How about a keychain for those late nights? What about a new chocker or bracelet for your next EDM festival? The possibilities are endless.  Here is a great project from happyhourprojects.com that you might like.

 

What you will need:

 

  • Hemp Glow in the Dark Cord
  • Size 6/0 seed beads
  • Scissors, a clipboard or other way to secure your bracelet while you work, and a ruler if estimating length isn’t one of your strong suits.

First, check your bead hole sizes against the end of your twine to make sure the bead will slide on easily.  Then, cut off three strands of twine about 12 inches long.  You will need enough extra length to be able to tie your bracelet on when it’s finished – like a friendship bracelet.  Tie an overhand knot about 1-1/2 to 2 inches down, to create your “tails”.

Clip it onto your clipboard to secure it, unless you have another method you like to use.  This works well for me, though.

 

Braid your bracelet about 2 inches.  You can actually make this more or less, to add more or fewer beads as you like.  No rules here, just do what you like!

 

Now, add a bead onto your outside strand.  It doesn’t matter whether you are pulling from the left or right first, just whichever strand you’re about to pass to the middle.  Slide it up snug with the knot, and continue your braid.  This will add it to the outside of your braid.

Do the same thing on the next strand, and then the next – add a bead to the strand just before you pass it to the middle.  Keep adding beads until you have enough to your liking.  I like 2 rows of 7 – so, 14 beads total.  (This is opposite of the Wish Bracelets – those, you add on so that the bead is placed inside the braid, rather than the outside, giving you only one row of beads.)

When you have enough to suit your tastes, it should be around 2-1/2 inches of beads, give or take, continue your braid normally (without adding beads).  Braid another 2 inches – making your bracelet a total length between approximately 6 to 6-1/2 inches.  This will fit an average sized wrist.  You can vary it to be more or less, depending on whether your recipient is likely to be an adult or a child.

Once you are ready to finish it off, just ties another overhand knot.  Cut your “tails” to even them up and match the other end – just make sure you’re leaving enough length that it can be tied onto a wrist.

 

Optionally – you may want your bracelet to be removable.  If that’s the case, you can find glue-on jewelry end caps.  Just trim the ends down to fit the cap, and use jewelry glue to adhere the cap.  If you’re looking for another project to see how this would work, I recently posted a layered woven bracelet you can take a look at.

That’s it!  A bracelet will take you about ten minutes – which makes it easy to whip up a few!

 

 

 

 

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *